Safety; Precautions; Power Lockout Procedure - Challenge CHAMPION 305 Instructions And Parts Manual

2.0 Safety

2.0 Safety

2.1 Precautions


This machine is designed for one-person operation. Never operate the machine with more than
one person.

Safe use of this machine is the responsibility of the operator. Use good judgment and common
sense when working with and around this machine.

Read and understand all instructions thoroughly before using the machine. If questions remain,
contact the dealer from which you purchased this machine. Failure to understand the operating
instructions may result in personal injury.

Only trained and authorized people should operate this machine.

Do not alter safety guards or devices. They are for your protection. Severe personal injury may
result.

Disconnect power before cleaning or performing maintenance. See Section 2.2 Power Lockout
Procedure.

Observe all caution labels and plates on this machine.

Be sure the cutter is properly grounded.

Be sure there is sufficient power to operate the cutter properly.

Keep foreign objects off the table and away from cutter blade.

BE EXTREMELY CAREFUL when handling and changing the cutter knife. Severe lacerations or
dismemberment could result from careless handling procedures.

Keep the floor around the cutter free of trim, debris, oil and grease.

When replacing hydraulic parts, loosen the connections slowly to release pressure. Never loosen
connections with the machine running.

If the cutter sounds unusual or operates abnormally, turn it off and consult the troubleshooting
section of this manual. If the problem cannot be corrected, have it checked by a qualified service
person.

CRUSH HAZARD, keep hands and fingers from under the clamp while clamping. Use Jogging
Aid to load paper, and use the backgauge to push paper out before unloading. DO NOT REACH
UNDER THE KNIFE AND CLAMP AREA!

2.2 Power Lockout Procedure

For maximum safety when making adjustments or repairs to your machine, be sure to lock out the
main power control switch to which the machine is connected. The switch should be moved to the
OFF position and a padlock placed in the loop. The person servicing the machine should hold the
key.
6
Figure 1