Challenge CHAMPION 305 Instructions And Parts Manual page 58

13.0 Repair and Replacement
12. Lock the jam nut securely in place.
13. Reconnect the hydraulic hoses.
the key is turned on and the cut buttons are pressed for the first time. Keep hands and tools
away.
14. Reconnect the power to the cutter and turn main power on.
15. Adjust the Knife up proximity switch actuator. Press the cut buttons once to turn on the
hydraulic motor and raise the knife and clamp. Allow machine to run for a few minutes to
work the air out of the system.
16. See Knife Installation and Set up for reinstalling the knife.
58
Clamp
Knife
Bar
Frame
Table
Figure 50
CRUSH HAZARD! Knife and clamp will return to the up position when
4-1/8"