7.0 Operation
IMPORTANT: DO NOT ATTEMPT TO OPERATE THE CUTTER UNTIL YOU HAVE THOROUGHLY
READ AND UNDERSTAND ALL OF THE FOLLOWING INSTRUCTIONS. CALL YOUR
AUTHORIZED CHALLENGE DEALER IF YOU STILL HAVE ANY QUESTIONS.
7.1 Power – Main Switch
Power is applied to the machine when the main power switch is turned to the "ON" position (Figure 7).
The display and line lights are turned on at this time.
The display and line lights will shut off after a few minutes (depending on setting) without any activity.
To restore power to the display and line lights, press either cut button.
7.2 Table Light
For machines with a fluorescent table light - the table light is turned on and off using a switch located
under the arch. The table light will also turn on and off with the main power, provided the table light
switch is in the "on" position. If the machine has an LED table light the light turns on and off with the
hydraulic motor.
Figure 6
OFF
Figure 7
ON
7.0 Operation
17