Line Light Adjustment (Incandescent Type) - Challenge CHAMPION 305 Instructions And Parts Manual

12.0 Adjustments
7. Tilt the control console back up and secure it with the two screws. Restore power to the
machine and perform a cut cycle. Recheck the gap to make sure it is still within the correct
range.
8. Also make sure that the distance between the knife blade edge and the bottom surface of the
clamp is greater than the knife latch gap. This ensures that if the knife were to drift down and
hang on the knife latch, the knife blade edge will not be exposed.
9. Once the knife latch is adjusted properly and the mounting screws are tight, tilt the control
console back up into place and secure it with the two screws.

12.6 Line Light Adjustment (Incandescent Type)

S/N's: 1509999 and below,
S/N's: 305M-J-151075 and below
The line light comes on whenever main power is turned to the ON position. The light from each of two
bulbs reaches the table after passing between the knife and clamp, (Figure 35).
Each light is focused with a socket head cap screw recessed into the arch, directly behind the
console, (Figure 36).
46
Figure 35
Figure 36