Clamp Cylinder Adjustment (Clamp Height) - Challenge CHAMPION 305 Instructions And Parts Manual

12.0 Adjustments

12.12 Clamp Cylinder Adjustment (Clamp Height)

If the clamp piston bottoms in the cylinder before the clamp makes contact with the table, or if the
clamp does not make full travel on the up stroke, the clamp cylinder may need adjustment.
To adjust:
1. Turn on machine. Start the hydraulic motor by pressing both cut buttons simultaneously.
Turn off the machine.
2. DISCONNECT THE POWER AND LOCK IT OUT! (See Power Lockout procedure, page 6).
3. Loosen the jam nut (Figure 44).
52
Lower Flow
Control Valve
Figure 43
Clevis
Jam Nut
Wrench Flat
Clamp
Cylinder
Figure 44