Challenge CHAMPION 305 Instructions And Parts Manual page 40

11.0 Hydraulic System
d. Setting the Minimum Pressure: Perform a cut cycle, after the clamp has contacted
the table and while the knife bar is coming down, read the pressure on the right hand
pressure gauge. It should be set at 400 p.s.i. If not, correct by using the up and
down arrow keys. When finished, choose C), to return to the Send mode, or D) Exit to
return to Diagnostics.
40
5.000
Set Maximum
>
Press /\ to Increase
Press \/ to Decrease
A) Main C) Send
B) Job D) Exit
5.000
Set Minimum
>
Press /\ to Increase
Press \/ to Decrease
A) Main C) Send
B) Job D) Exit