Line Light Adjustment (Led Type) - Challenge CHAMPION 305 Instructions And Parts Manual

To adjust line light:
1. Let the console down by removing the two screws at the top.
2. Place a wide sheet(s) of paper on the cut stick to view the line.
3. Using a 3/16" hex wrench, turn one of the cap screws until you see a 1/16-1/8" beam.
4. Similarly, turn the adjustment screw of the other bulb until one, continuous beam is seen
across the cut stick.
Bulb replacement:
1. Make sure the power is OFF and remove key. DISCONNECT THE POWER AND LOCK IT
OUT! (See Power Lockout procedure, page 6)
2. Lower the console.
3. Remove the old bulb by lightly pushing bulb into the socket and turning it counter-clockwise.
CAUTION!- If the bulb is still hot, allow a few minutes to cool before changing.
4. Insert the new bulb into the socket and twist clockwise until the bulb locks into place.
5. Reattach the console.
6. Reconnect the power and turn ON.
7. If necessary, adjust the line as above.
8. Unless the cutter will be operated immediately, turn the power off.

12.7 Line Light Adjustment (LED Type)

S/N's: 305M-J-151076 and above
The line light comes on whenever main power is turned to the ON position and stays on until the
machine goes into sleep mode. Light reaches the table after passing between the knife and clamp,
(Figure 37)
Figure 37
12.0 Adjustments
47