To Light The Pilot - Aga-Rayburn Coalbrookdale Little Wenlock Gas Power Flue Installation And Servicing Instructions

TO LIGHT THE PILOT

Ensure that the control knob is in the OFF (●) position
(Fig. 19).
Fully depress the control knob and turn anti-clockwise
(keeping the control valve fully depressed) until the pilot
position ( ) is reached (Fig. 20). If the pilot has not lit
repeat the operation.
Once the pilot is lit continue to hold in the control knob for
a further 10-15 seconds to establish the pilot. When the
control knob is released the pilot should remain alight. If
the pilot fails to remain alight refer to fault finding section
of this document.
If required the pilot may be lit by a long spill or taper as
follows:
Open the door of the stove (using the tools supplied) (See
Fig. 11).
Apply a lighted long spill or taper to the pilot (See Fig. 21)
positioned at the front LH side of the burner tray.
Fully depress the control knob and turn anti-clockwise
(keeping the control knob fully depressed) until the spark
position ( ) has been removed and the pilot should light.
Once the pilot is lit remove the long spill or taper,
continue to hold the control knob for 10 to 15 seconds to
establish the pilot. When the knob is released, the pilot
should remain alight. If the pilot fails to remain alight,
repeat the procedure, but hold the knob in longer.
When pilot is established close and lock the door
(using the tools supplied).
TO LIGHT STOVE
If the pilot is not alight, follow procedure to light pilot.
Turn the control knob anti-clockwise to the full on position
( ) (Fig. 22). The main burner will light. At this setting the
pressure should be 17.7 +/-1.0mbar with an inlet
pressure of 20mbar for natural gas, or 36 +/-1.0mbar with
an inlet pressure of 37mbar for propane.
Depress and turn the control knob clockwise to the pilot
position ( ) (Fig. 23). The stove will go out and the pilot
will remain alight. Remove the pressure gauge and
replace the test point sealing screw.
Turn stove to maximum setting (
for gas soundness.
) (Fig. 24) and check
16
FIG 19.
FIG 20.
FIG. 21.
FIG 22.
FIG 23.
FIG 24.
DESN 511313