Aga-Rayburn Coalbrookdale Little Wenlock Gas Power Flue Installation And Servicing Instructions page 10

THE FLUE
ALONG AN INSIDE/OUTSIDE WALL
1. Mark position of the top of the hearth on the inside
face of the exterior wall and also the flue hole position
(Fig. 9).
Note: Check that the flue length will be between
200mm and 2M.
2. Drill the hole for the flue pipe, the centre being 41mm
above the top of the hearth and 45mm from the
corner.
3. The flue pipe and elbows can be assembled as
described previously, see Fig. 8.
PLEASE NOTE THAT THE FLUE PIPE IS HOT, IF THE
FLUE IS RUNNING ALONG THE INSIDE WALL THE
FITTING OF A NON COMBUSTIBLE FLUE COVER IS
STRONGLY RECOMMENDED.
FIG. 9
9
DESN 511302