Securing The Machine For Transport; Lifting The Machine - Toro STX-38 Operator's Manual

5. Lower the grinder about an inch and swing it back
over the stump.
6. Repeat step 5 until you have reached ground level.
7. Raise the grinder so that it is about an inch below the
top of the remaining stump, move the machine forward
a few inches, and repeat steps
have ground away the entire stump..
8. If there are any large roots to be ground, position the
grinder over each root and use the traction control and
grinder control to move the grinder along the root,
grinding it away.
Securing the Machine for
Transport
When transporting the machine on a trailer, always use the
following procedure:
Important: Do not operate or drive the machine on
roadways.
1. Stop the engine.
2. Lower the grinder.
3. Secure the machine to the trailer with chains or straps
using the tie-down/lift loops at the front and rear of
the machine (Figure 22
Note: Refer to your local ordinances for trailer and
tie-down requirements.
Figure 21
4 through 6 until you
and Figure 23).
1. Front tie-down loop
1. Rear tie-down loops

Lifting the Machine

You can lift the machine using the tie-down/lift loops as lift
points (Figure 22 and
18
Figure 22
1
Figure 23
Figure 23).
G024909