Toro STX-38 Operator's Manual page 5

Safe Handling of Fuels
•
To avoid personal injury or property damage, use
extreme care in handling gasoline. Gasoline is extremely
flammable and the vapors are explosive.
•
Extinguish all cigarettes, cigars, pipes, and other sources
of ignition.
•
Use only an approved fuel container.
•
Never remove fuel cap or add fuel with the engine
running.
•
Allow engine to cool before refueling.
•
Never refuel the machine indoors.
•
Never store the machine or fuel container where there is
an open flame, spark, or pilot light such as on a water
heater or on other appliances.
•
Never fill containers inside a vehicle or on a truck or
trailer bed with a plastic liner. Always place containers on
the ground away from your vehicle before filling.
•
Remove equipment from the truck or trailer and refuel it
on the ground. If this is not possible, then refuel such
equipment with a portable container, rather than from a
fuel dispenser nozzle.
•
Keep the nozzle in contact with the rim of the fuel tank
or container opening at all times until fueling is complete.
•
Do not use a nozzle lock open device.
•
If fuel is spilled on clothing, change clothing immediately.
•
Never overfill fuel tank. Replace fuel cap and tighten
securely.
Slope Operation
Slopes are a major factor related to loss-of-control and
tip-over accidents, which can result in severe injury or death.
All slopes require extra caution.
•
Do not operate the machine on hillsides or slopes
exceeding the angles recommended in the following table.
Front Facing Rear Facing
Uphill
16°
Note: See also the
Slope Indicator (page
•
Operate up and down slopes with the front end of
the machine uphill.
•
Remove obstacles such as rocks, tree limbs, etc. from the
work area. Watch for holes, ruts, or bumps, as uneven
terrain could overturn the machine. Tall grass can hide
obstacles.
•
Use only Toro-approved accessories. Accessories can
change the stability and the operating characteristics
of the machine. Warranty may be voided if used with
unapproved accessories.
•
Keep all movements on slopes slow and gradual. Do not
make sudden changes in speed or direction.
Side Facing Uphill
Uphill
16° 16°
7).
•
Avoid starting or stopping on a slope. If the machine
loses traction, proceed slowly, straight down the slope.
•
Avoid turning on slopes. If you must turn, turn slowly
and keep the heavy end of the machine uphill.
•
Do not operate near drop-offs, ditches, or embankments.
The machine could suddenly turn over if a track goes
over the edge of a cliff or ditch, or if an edge caves in.
•
Do not operate on wet grass. Reduced traction could
cause sliding.
•
Do not park the machine on a hillside or slope without
lowering the grinder to the ground and chocking the
tracks.
Maintenance and Storage
•
Disengage the hydraulics, lower the grinder, stop the
engine, and remove the key. Wait for all movement to
stop before adjusting, cleaning, or repairing.
•
Clean debris from the grinder, drives, mufflers, and engine
to help prevent fires. Clean up oil or fuel spillage.
•
Let the engine cool before storing and do not store near
flame.
•
Do not store fuel near flames or drain indoors.
•
Park the machine on level ground. Never allow untrained
personnel to service the machine.
•
Use jack stands to support components when required.
•
Carefully release pressure from components with stored
energy.
•
Disconnect the battery or remove the spark plug wires
before making any repairs. Disconnect the negative
terminal first and the positive last. Reconnect positive
first and negative last.
•
Keep hands and feet away from moving parts. If possible,
do not make adjustments with the engine running.
•
Keep all parts in good working condition and all hardware
tightened. Replace all worn or damaged decals.
•
Keep nuts and bolts tight. Keep equipment in good
condition.
•
Never tamper with safety devices.
•
Keep the machine free of grass, leaves, or other debris
build-up. Clean up oil or fuel spillage. Allow the machine
to cool before storing.
•
Stop and inspect the equipment if you strike a foreign
object outside of the stump wood. Make any necessary
repairs before restarting.
•
Use only genuine Toro replacement parts to ensure that
original standards are maintained.
•
Battery safety:
– Charge batteries in an open, well ventilated area, away
from spark and flames. Unplug the charger before
connecting or disconnecting it from the battery. Wear
protective clothing and use insulated tools.
5