Setup; Checking Fluid Levels; Charging The Battery; Opening The Lift Valve - Toro STX-38 Operator's Manual

Setup

Checking Fluid Levels

Before starting the engine for the first time, check the engine
oil and hydraulic fluid levels; refer to
Level (page 24) and Checking the Hydraulic-fluid Level (page
36) for more information.

Charging the Battery

Charge the battery; refer to
for more information.

Opening the Lift Valve

Before you can raise the grinder and move the machine,
you must open the lift valve located under the control panel
(Figure 4). Turn the knob counter clockwise to allow you to
lift the grinder. The further you turn the knob, the faster the
head will raise and lower when activated.
Checking the Engine-oil
Charging the Battery (page 30)
Figure 4

Product Overview

1
6
2
1. Control panel 3. Engine
4. Battery
2. Chip shield

Controls

Become familiar with all the controls
start the engine and operate the machine.
1 2 3 4
1. Key switch
2. Throttle lever
3. Engine indicator light
4. Hour meter
5. Traction control
Key Switch
The key switch has three positions: Off, Run, and Start.
•
To start the engine, rotate the key to the Start position.
Release the key when engine starts and it will move
automatically to the Run position.
•
To stop the engine, rotate the key to the Off position.
11
2
3
4
5
Figure 5
5. Grinder
6. Track
(Figure 6) before you
5 6 7 8
G024907
Figure 6
6. Reference bar
7. Reverse safety plate
8. Grinder control lever
9. Handle
G024906
9