•
Keep all parts in good working condition and all
hardware tightened.
•
Use care when loading or unloading the machine
into a trailer or truck.
Moving a Non-Functioning
Machine
Important:
Do not tow or pull the machine
without first opening the tow valves, or you will
damage the hydraulic system.
1.
Engage the parking brake and lower the grinder.
2.
Shut off the engine and remove the key.
3.
Remove the bottom shield.
4.
Using a wrench, turn the tow valves on the
hydraulic pumps twice counter-clockwise
21).
Figure 21
1. Tow valves
5.
Install the bottom shield and tow the machine
as required.
6.
After repairing the machine, close the tow valves
before operating it.
Securing the Machine for
Transport
Important:
Do not operate or drive the machine
on roadways.
1.
Park the machine on a level surface, engage
the parking brake (if applicable), and lower the
grinder.
2.
Shut off the engine and remove the key.
3.
Secure the machine to a trailer with chains or
straps using the tie-down/lift loops at the front
and rear of the machine
(Figure
g019842
(Figure 22
and
Figure
23). Refer to your local ordinances for trailer and
tie-down requirements.
1. Front tie-down/lift loops
1. Rear tie-down/lift loops
Lifting the Machine
You can lift the machine using the tie-down/lift loops
as lift points
(Figure 22
17
Figure 22
Figure 23
and
Figure
23).
g319379
g319380