Lifting The Machine - Toro SGR-13 Original Instructions Manual

Figure 9
1. Pivot point
3. Move the machine to the front of the stump and
engage the parking brake.
4. Move throttle up to the E
cutting wheel will begin rotating.
5. Swing the cutting wheel to 1 side
then lower it approximately 1 to 2.5 cm (1/2 to 1
inch) into the front-top corner of the stump.
Figure 10
6. Using a sweeping motion, swing the cutting
wheel back and forth, lowering the cutting wheel
approximately 1 to 2.5 cm (1/2 to 1 inch) before
g024547
2. Pivot point when the
parking brake is engaged
position. The
NGAGE
(Figure 9),
g024062
each sweep, until you have removed the front
portion of the stump to ground level (A through
D in Figure 10).
7. Raise the cutting wheel, release the parking
brake, and move the machine forward a few
centimeters (inches). Engage the parking brake.
8. Repeat steps
removed the stump (E through H in
9. Move throttle to the D
the handle down enough to raise the cutting
wheel off the ground. Wait for the cutting wheel
to stop rotating then release the parking brake
and pull the machine away from the stump.
Note:
Do not let the front of the machine touch
the ground until the cutting wheel has stopped
turning.
10. Shut off the engine; refer to
Engine (page

Lifting the Machine

Use the handles shown in
1. Lift handle (4)
11
5 and 7 until you have completely
Figure
position, push
ISENGAGE
Shutting Off the
10).
Figure 11 as lift points.
Figure 11
10).
g205090