Installing The Front Cover; Removing The Bottom Shield; Installing The Bottom Shield - Toro STX-38 Operator's Manual

WARNING
If the machine has been running, both the
cover and the muffler under the cover will be
hot and can cause severe burns if you touch
them.
Allow the machine to cool before removing
the cover.
2. Loosen the 2 screws securing the front cover to the
machine (Figure 24).
G021242
Figure 24
1. Cover
3. Slide the cover forward slightly and pull up to remove
the cover (Figure 24).

Installing the Front Cover

1. Lower the grinder, stop the engine, and remove the key.
2. Slide the front cover into place and tighten the 2 screws
securing it to the machine

Removing the Bottom Shield

1. Lower the grinder, stop the engine, and remove the key.
2. Loosen the 2 bolts securing the bottom shield
sequentially until the shield is free
Important: The fasteners on the bottom shield
are designed to remain on the cover after removal.
Loosen both bolts a few turns so that the shield is
loose but still attached, then go back and loosen
them until the shield comes free. This prevents
you from accidentally stripping the bolts free of
the retainers.
1
2
2. Screws
(Figure 24).
(Figure 25).
1. Bottom shield
3. Pull the shield back and out of the machine.

Installing the Bottom Shield

1. Lower the grinder, stop the engine, and remove the key.
2. Slide the bottom shield into the machine
Note: You may need to lift up on the bottom shield to
ensure that it seats correctly.
3. Secure the shield with the bolts that you loosened
previously.
21
Figure 25
2. Bolts
(Figure 25).