RED ONE Quick Start Manual page 7

20. Install LCD to long stud on arm and tighten thumb screw. Connect cable between LCD
and MONITOR connector on side of camera body.
ALWAYS
ALIGN RED-DOTS
21. Connect cable from cradle mount to POWER connector on rear of camera.
ATTACH
POWER CABLE
TO CAMERA
22. Slide RED BRICK® battery into v-mount battery plate on Cradle Assembly.
NOTE: To ensure a good connection between battery and RED Cradle V-plate adapter, it
is recommended to perform a break-in sequence. To break-in: Fully engage/disengage a
RED BRICK® battery approx. 20 times in V-plate adaptor.
NOTE:
ENSURE LOCK BUTTON POPS OUT AND MAKES AN
AUDIBLE CLICK
23. Adjust balance of camera by loosening wing nuts and adjusting Rods, Universal Mount,
Cradle Assembly, Right Handle, and Shoulder Dovetail.
TIGHTEN THUMB-SCREW
TO SECURE LCD
WHEN INSTALLING RED BRICK.
SLIDE RED BRICK
ONTO V-LOCK
BATTERY PLATE ON
CRADLE ASSEMBLY