Bottom Plate; Mounting Holes - RED ONE Quick Start Manual

CAMERA ASSEMBLY PROCEDURE
The following instructions will outline basic assembly of the RED ONE™ camera body,
BASE PRODUCTION PACK, RED ™ LCD, REDFLASH ™ , RED DRIVE®, and RED
BRICK®.
When connecting cables between camera and components, align Red dots
on cable and connector and press in rmly to establish a secure connection.
Wingnuts can be indexed by pulling out and rotating to desired position. This
may be necessary during assembly to clear components.
1.
Remove your RED ONE
place on a suitable work surface preferably in a dust-free environment.
2.
Thoroughly inspect your camera and accessories.
• If there is any physical damage to your camera or accessories, please contact us
immediately at info@red.com.
3.
Assemble bottom plate, wing nuts and washers - do not tighten.
4.
Set camera body onto bottom plate and align four (4) mounting holes - two (2) on each
side - install Allen bolts and tighten.
5.
Slide rods through mounting holes in bottom plate until centered. Lock in place using
wing nuts.

MOUNTING HOLES

ATTACH CAMERA TO

BOTTOM PLATE

*** TIP***
HAND TIGHTEN THE 4
SCREWS, THEN
SINCH TIGHT WITH
3/16 ALLEN WRENCH
6.
Ensure shoulder dovetail lock is on "R" side of RED ™ logo and slide into bottom plate.
Install end with RED ™ logo facing rear of camera. Secure in place by sliding lock to "D"
side of RED ™ logo.
UN-LOCKED
™
camera body and all accessories from packaging and
BASE PRODUCTION PACK
ASSEMBLY SHOWN
WITH TOP MOUNT AND TOP HANDLE
BOTTOM PLATE
LOCKED