Cid 0110 Fmi 03; Cid 0110 Fmi 04 - Perkins 1106D Troubleshooting Manual

82
Troubleshooting Section
•
The engine oil pressure signal is within the limits of
410 kPa (59 psi) to 520 kPa (75 psi) with a pressure
variation of less than 1.68 kPa (0.25 psi)for more
than 30 seconds.
•
The engine oil pressure signal remains constant
for 30 seconds.
System Response:
If equipped, the diagnostic lamp will flash. The ECM
will log the diagnostic code.
The ECM will flag the engine oil pressure as invalid
data. The data for engine oil pressure is set to a
default value of 500 kPa (72 psi). The electronic
service tool will display "Conditions Not Met" on the
status screen.
Possible Performance Effect:
None
Troubleshooting:
This diagnostic code is designed to detect the loss
of the 5 Volt supply to the sensor.
Perform the following diagnostic procedure: "Engine
Pressure Sensor Open or Short Circuit - Test"
Results:
•
OK – STOP.

CID 0110 FMI 03

Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the
following conditions:
• The signal voltage from the engine coolant
temperature sensor is greater than 4.95 Volts DC
for more than eight seconds.
•
The ECM has been powered for at least two
seconds.
System Response:
If equipped, the diagnostic lamp will flash. An active
diagnostic code will be generated after 8 seconds.
The diagnostic code will be logged if the engine has
been operating for more than 7 minutes.
This document is printed from SPI². Not for RESALE
The ECM will default to 90 °C (194 °F) for engine
coolant temperature. "Voltage Above Normal" will
be displayed next to the status for "Engine Coolant
Temperature" on the electronic service tool.
Possible Performance Effect:
•
Poor stability
• Poor cold running
• White smoke
Troubleshooting:
The diagnostic code will detect an excessively high
voltage from the engine coolant temperature sensor.
Perform the following diagnostic procedure: "Engine
Temperature Sensor Open or Short Circuit - Test"
Results:
• OK – STOP.

CID 0110 FMI 04

Conditions Which Generate This Code:
The Electronic Control Module (ECM) detects the
following conditions:
i03797150
•
The signal voltage from the engine coolant
temperature sensor is less than 0.2 Volts DC for
more than eight seconds.
•
The ECM has been powered for at least two
seconds.
•
Diagnostic code 0168-01 is not active.
System Response:
The ECM will default to 90 °C (194 °F) for engine
coolant temperature. "Voltage Below Normal" will
be displayed next to the status for "Engine Coolant
Temperature" on the electronic service tool.
If equipped, the diagnostic lamp will flash. An active
diagnostic code will be generated after 8 seconds.
The diagnostic code will be logged if the engine has
been operating for more than 7 minutes.
Possible Performance Effect:
•
Poor stability
• Poor cold running
KENR6201-01
i03797151