Cid 0005 Fmi 05; Cid 0005 Fmi 06 - Perkins 1106D Troubleshooting Manual

KENR6201-01
•
Diagnostic code 190-08 is not active.
•
No 0110 diagnostic codes are active.
System Response:
If equipped, the diagnostic lamp will flash and the
derate lamp will come on. An active diagnostic code
will be generated. The ECM will log the diagnostic
code. The ECM will trigger a snapshot.
Possible Performance Effect:
The engine will be derated while this diagnostic code
is active.
Troubleshooting:
Perform the following diagnostic procedure: "Injector
Data Incorrect - Test"
Results:
• OK – STOP.

CID 0005 FMI 05

Conditions Which Generate This Code:
This diagnostic code is designed to indicate an open
circuit (low current) in either the solenoid or the wiring
for the electronic unit injector for No. 5 cylinder.
The Electronic Control Module (ECM) detects the
following condition:
•
A low current condition (open circuit) for each of
five consecutive attempts to operate
•
Battery voltage is higher than 9 volts for 2 seconds.
System Response:
The ECM will log the diagnostic code. If equipped,
the diagnostic lamp will flash.
Possible Performance Effect:
The engine will have low power and/or rough running.
Troubleshooting:
When the" Injector Cutout Test" is performed, a faulty
electronic unit injector will indicate a low reading in
comparison with the other electronic unit injectors.
This document is printed from SPI². Not for RESALE
An electrical fault can prevent the electronic unit
injector from operating. An open circuit in the wiring
that is unique to the electronic unit injector will prevent
that individual electronic unit injector from operating.
An open circuit in common wiring within the ECM can
prevent the three electronic unit injectors that share
that common wiring from operating.
The ECM will continue to attempt to operate the
electronic unit injector after the diagnostic code has
been logged but an open circuit will prevent the
operation of the electronic unit injector.
Perform the following diagnostic procedure: "Injector
Solenoid Circuit - Test"
Results:
•
OK – STOP.

CID 0005 FMI 06

i03797030
Conditions Which Generate This Code:
This diagnostic code is designed to indicate a short
circuit (high current) in either the solenoid or the
wiring for the electronic unit injector for No. 5 cylinder.
The Electronic Control Module (ECM) detects the
following conditions:
• A high current condition (short circuit) for each of
five consecutive attempts to operate
•
Battery voltage above 9 volts for 2 seconds
System Response:
The ECM will log the diagnostic code. If equipped,
the diagnostic lamp will flash.
Possible Performance Effect:
The engine will have low power and/or rough running.
Troubleshooting:
When the "Injector Cutout Test" is performed, a faulty
electronic unit injector will indicate a low reading in
comparison with the other electronic unit injectors.
An electrical fault can prevent the electronic unit
injector from operating. A short circuit in the wiring or
the ECM that is unique to one electronic unit injector
will prevent that individual electronic unit injector from
operating. A short circuit in common wiring within the
ECM can prevent the three electronic unit injectors
that share that common wiring from operating.
77
Troubleshooting Section
i03797033