LifeFitness INTEGRITY Series Assembly Instructions Manual page 22

15. Locate the Left Accessory Tray (11). Carefully slide the tray
into the top of the Left Upright (1) as shown
until fully seated. Secure the accessory tray to the Left Top
Mounting Plate (H) using four Screws (21). Repeat the proce
dure for the Right Accessory Tray (12) and Right Top Mount
ing Plate (J).
16. Tighten all Upright Bolts securely.
17. Replace the Motor Cover (E) and secure the Motor Cover
to the Frame (C) using the four previously removed Screws
(D). Tighten the Screws securely. Do not overtighten the
Screws.
18. Replace the Front Grill (B) and secure the Front Grill to the
Frame (C) using the four previously removed Screws (A).
Tighten the Screws securely. Do not overtighten the Screws.
19. Locate one Screw Grommet (18). Insert the Screw Grommet
into the square hole located above the top inside mounting
bolt of the Right Upright (2). Repeat for the remaining Screw
Grommet and Left Upright (1).
20. Locate one Lower Upright Cover (10). Position the Lower
Upright Cover at the bottom notch of the Right Upright (2)
making sure the top lip of the Upright Cover is
engaged under the outside notch of the Right Upright.
Secure the Upright Cover to the Right Upright using one
Screw (16). Tighten the Screw securely. Do not overtighten
the Screw. Repeat the procedure for the Left Upright (1)
and remaining Upright Cover.
21. Locate the Upright Plugs (25). Insert one Upright Plug into
each of the two access holes located on the lower outside of
the Left and Right Uprights (1 & 2).
22. Locate and press the Handlebar Caps (13) over the ends of
the Handlebars (3). Be sure the Handlebar Caps are fully
seated.
23. Using two Screws (16) each, attach the two Rear Frame End
Caps (14) to the Frame (C) as shown. Tighten the Screws
securely. Do not overtighten the Screws.
24. The treadmill striding belt must be "walked-in" for five
minutes after assembly is complete.
Plug the treadmill into an appropriate outlet. Turn the tread
mill on at the on/off switch. Select quick start from the con
sole. Increase the speed to 3 mph (4.8 km/h). Start walking
in the front left corner of the walking surface and drift to the
back, move to the center of the deck and walk towards the
front, and finally walking to the right corner and drifting to the
back. Continue pattern for five minutes.
25. Refer to the specific treadmill's Operation Manual for power
requirements, proper line cord routing, and other critical
product information before connecting the treadmill to a
power source.
20
11
21
2
1
2
C
12
18
16 10
25
3
13
14
16
14