GAS CONNECTION
To make the connection, connect the mains line to the
appliance's connection pipe, fitting a shut-off tap (A),
to allow the gas supply to be cut off when necessary.
Important
The tap (A), not supplied with the appliance,
must be installed in an easily accessible
position and its status (on or off) must be
obvious at a glance.
This appliance shall be installed only by au-
thorised personnel and in accordance with
the manifacturer's installation instructions,
local gas fitting regulations, municipal
CONVERSION OF THE GAS SUPPLY
Always install a quick-closing ON/OFF valve (A)
(no t supplied).
For Natural gas equipment, fit the gas regulator (B)
supplied with appliance to gas connection.
Caution - warning
For natural gas equipment this appliance
must be fitted with a Bromic 98 gas regula-
tor (AGA Approval No.5862) supplied with the
appliance. Do not use any other gas regula-
tor.Ensure regulator is fitted with respect to
the gas flow marked on the housing of the
regulator.
The constructor has tested the appliance with its own
mains gas, identified by the sticker applied to the na-
meplate.
If the type of gas to be connected is different from that
used for testing, proceed as follows.
1 - Turn off the gas supply tap (A).
2 - Change the top burner nozzles (see page 14).
3 - Change the top burner pilot light nozzles
(see page 15).
4 - Adjust the minimum settings of the gas control
valves of the burners (see 13).
5 - Remove the sticker from the nameplate and ap-
ply the new one to identify the gas being used.
Important
On completion of the operation, make sure that
there are no gas leaks or malfunctions. If con-
verting from Natural Gas to Universal LPG
make sure the Natural Gas Regulator is re-
moved.
building codes, water supply regulations,
electrical wiring regulations, AS 5601/AG
601-Gas installations and any other statuto-
ry regulations.
.
A
- 11 -
A
IDM-39603612100.tif
IDM-39603612200.tif
A
B
1 rubin copia.tif
IT
IT
GB
AUS
DE
DE
FR
FR
ES
ES
CSI
convers gas aus.tif
Need help?
Do you have a question about the 0G0FA0 and is the answer not in the manual?