Fault - Angelo Po 0G0FA0 Use And Installation Manual

To carry out this operation,
proceed as follows.
1 - Turn off the gas supply
tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and
remove the control panel
(C).
4 - Undo the screw (D) of the
pressure connection.
5 - Connect the pressure
gauge (E) to the pres-
sure test point.
6 - Light all of the top burners and turn the knobs to
the full flame setting (see page 6) then check that
the pressure reading is the same as the values
provided in the table (see back of manual).
The appliance has been tested before being put
into service. The information provided below is
intended to assist in the identification and correction
of any anomalies and malfunctions which might occur
during use. The user can solve some of these prob-
IT IT

Fault

AUS
GB
Smell of gas.
DE
DE
FR
FR
The pilot light does not ignite.
ES ES
The pilot light goes out.
The pilot light ignites but the burner
remains off.
The flame is yellow.
CHECKING GAS PRESSURE
TROUBLESHOOTING
Occasional leak because flame
The spark ignition devices are not
Air in pipelines due to long period
The thermocouple has not warmed
Burner dirty, heat exchange pipes
clogged, condensation drips.
B
C
A
7 - Turn off the burner, disconnect the pressure
gauge and restore the initial conditions after com-
pleting the operation.
FAULT
lems himself, but for others specific technical knowl-
edge or skill is required, and so they must only be
carried out by qualified staff with recognised experi-
ence acquired in the specific sector of operation.
Causes
has gone out.
working.
out of use.
up enough.
- 8 -
IDM-39603611800.tif
Remedies
Turn off the gas supply tap and
ventilate the room.
Check that the ignition devices are
in good working order. Light by
hand with a naked light.
Important
Contact the after-sales service.
Make more attempts to light the
flame.
Make more attempts to light
the flame.
Check the condition of the
thermostat and activate any
ignition enabling device.
Contact the after-sales service.
E
D
6