Find The Example Project; Execute The Project Under Toolchains; Keil Mdk; Figure 3-7 Template Project Folder Path - Nuvoton NuMicro M252 Series User Manual

Find the Example Project

Use the "Template" project as an example. The project can be found under the BSP folder as shown
in Figure 3-7.

M251_Series_BSP_CMSIS_V3.XX.XXX

SampleCode

Template

GCC

Keil

IAR

Execute the Project under Toolchains

Open and execute the project under the toolchain. The section 3.6.1, 0, and 3.6.3 describe the steps
of executing project in Keil MDK, IAR EWARM and NuEclipse, respectively.
3.6.1

Keil MDK

This section provides steps to beginners on how to run a project by using Keil MDK.
1. Double click the "Template.uvproj" to open the project.
Note: If Figure 3-8 warning message jumps out, please migrate to version 5 formats as shown in
Figure 3-9. The ".uvproj" filename extension will change to ".uvprojx".

Figure 3-8 Warning Message of "Device not found"

Aug. 02, 2019

Figure 3-7 Template Project Folder Path

Page 28 of 38
NuMaker-M252SD
Rev 1.00