4. Figure 3-17 shows the debug mode under IAR EWARN. Click "Go" and the debug message will
be printed out as shown in Figure 3-18. User can debug the project under debug mode by
checking source code, assembly language, peripherals' registers, and setting breakpoint, step run,
value monitor, etc.
Figure 3-18 Debug Message on Serial Port Terminal Windows
3.6.3
NuEclipse
For more information about how to use NuEclipse, please refer to the NuEclipse User Manual.
Aug.
02, 2019
Figure 3-17 IAR EWARM Debug Mode
Page 33 of 38
NuMaker-M252SD
1 2 3
1. Go
2. Break
3. Reset
Rev 1.00