Table of Contents
Advertisement
BSP Firmware Download
Download and unzip the
Board Support Package
Hardware Setup
1. Open the virtual COM (VCOM) function by changing Nu-Link2-Me VCOM Switch No. 1 and 2 to
ON.
2. Connect the ICE USB connector shown in Figure 3-4 to the PC USB port through USB cable.
3. Find the "Nuvoton Virtual COM Port" on the Device Manger as Figure 3-5.
Aug.
02, 2019
(BSP).
Figure 3-3 Open VCOM Function
Figure 3-4 ICE USB Connector
Page 26 of 38
NuMaker-M252SD
Rev 1.00
Advertisement
Table of Contents
