Duplo DocuCutter CC-229 Operational Manual page 19

USER DEFINE JOB
Note: User define job can only be job #8 - #13.
1. Press to select desire job# (8-13) to program then
press .
2. Press and hold
Mode" as seen.
F L
INISH ENGTH
3. Press to move cursor to "L" to set finishing length.
4. Press to increase length by 0.1 mm or press
decrease length by 0.1 mm. Hold
adjustment.
G S
UTTER IZE
Note: If no gutter, set gutter to "0".
5. Press to move the cursor to "G" Cutting Gutter, repeat step #4 to set the gutter size.
M S
ARGIN IZE
Note: If no margin, set mutter to "0".
6. Press to move the cursor to "M" Top Margin, repeat step #4 to set the margin cut.
C
REASE SETTINGS
Note: Maximum of 4 (A, B, C and D) creases can be program.
7. Press to move the cursor to "A", "B", "C" or "D". Repeat step #4 to set crease position.
P
APER SIZE
8. Press to move cursor to "Size". Repeat step #4 to set paper size. LT size is 279.4 mm.
for 2 seconds to enter "User Define
or
Figure 2
Settings
Size
L
G
M
A
B
to
C
D
for fast
Page 19
Original paper size (length)
Finished length
Gutter size
Margin size
st
1 Crease setting
nd
2 Crease setting
rd
3 Crease setting
th
4 Crease setting