Interface Module Leds - Cisco NCS 560-4 Hardware Installation Manual

Interface Module LEDs

Table 25: Power and Status LEDs Combination
PWR LED
State
Light
Green
Flashing
Light
Green and
Green
alternatively
Green
Interface Module LEDs
Table 26: Interface Module LED Details
LED
PID
Power
(PWR)
Cisco NCS 560-4 Router Hardware Installation Guide
114
STAT LED Indication
State
Red Power is OK and the
field-programmable gate array (FPGA)
is nfigured successfully, but FPGA
image validation failed.
Off FPGA configured and core validated
successfully.
FPGA image passed the control to
micro-loader to boot ROMMON.
Amber The digital code signing functionality
reported upgrade FPGA image
validation error and is continuing with
the FPGA image.
Red The digital code signing functionality
reported failure in the ROMMON
image validation.
Off IOS is successfully booted
Color/State Description (2x100G)
— N560-IMA2C
Off Disabled/no power to
IM
Green Enabled and power
rails on IM in range
Comment
Image validation failed. System is in hung
state.
System is up with ROMMON. Both the
FPGA image is validated successfully, but
the booted ROMMON (primary or
secondary) is undetermined.
System is up with ROMMON. FPGA
image is validated successfully, but the
booted ROMMON (primary or secondary)
is undetermined.
FPGA is up but both primary and
secondary ROMMON failed. System is in
hung state.
IOS writes into FPGA register to indicate
that it has booted, FPGA stops flashing
PWR LED and turns Green. Software now
controls the STAT LED.
Description (8x10G) Description (8/16x1G
+ 1x10G)
A900-IMA8Z A900-IMA8CS1Z-M
Disabled/no power to Disabled/no power to
IM IM
Enabled and power Enabled and power
rails on IM in range rails on IM in range
Pinout and LED Details
Description
(1x100G/200G)
N560-IMA1W
No power to IM
All power rails are
in range