Cisco NCS 560-4 Hardware Installation Manual page 49

Installing the Cisco NCS 560-4 Router
Figure 14: Installing the Mounting Brackets for the 23-inch EIA Rack
Step 4 Position the chassis in the rack as follows:
• If the front of the chassis (front panel) is at the front of the rack, insert the rear of the chassis between
the mounting posts.
• If the rear of the chassis is at the front of the rack, insert the front of the chassis between the mounting
posts.
Step 5 Align the mounting holes in the bracket with the mounting holes in the equipment rack.
Do not use interface module and power supply ejector handles to lift the chassis; using the handles to lift the
chassis can deform or damage the handles.
Cisco NCS 560-4 Router Hardware Installation Guide
Installing the Router in a Rack
41