Interface Module Leds - Cisco ASR 903 Installation Manual

Chapter 5 Troubleshooting
Table 5-12
LED
Power
(PWR)
Status
(STAT)
Active
(ACTV)
Management
port
(MGMT)
Sync status
(SYNC)
USB flash
(MEM)
BITS

Interface Module LEDs

Table 5-13
interface modules:
•
•
•
OL-25178-03
RSP LEDs
Color/State Description (two LEDs for eachT1/E1 port)
Off Disabled/no power to RSP
Green Power rails on RSP in range
Off Disabled/power down
Red Failure to boot (lit at reset)
Yellow Rommon booted
Green IOS booted and running
Off Not available
Yellow Standby (indicates standby RSP)
Green Active (indicates active RSP)
Off No connection
Green Connected with no activity
Flashing Connected with activity
green
Off Not enabled
Yellow Free run
Flashing Holdover
yellow
Green Locked to source
Flashing USB activity
green
Off Out of service/not configured
Amber Fault or loop condition
Green In frame/working properly
summarizes the interface module LEDs. This LED summary applies to the following
SFP Gigabit Ethernet Interface Module
RJ45 Gigabit Ethernet Interface Module
XFP 10 Gigabit Ethernet XFP Interface Module
Cisco ASR 903 Router Hardware Installation Guide
LED Summary
5-9