Connecting the Router to the Network
Figure 47: Securing the Cables Side View
1
Position of the IM Card cables (dust filter side) on
the cable management bracket
3
Postion of the RSP cables on the cable management
bracket
Connecting the Router to the Network
This section describes the various ways to connect the router to the network.
Connecting Console Cables
Note
You cannot use the USB and RS232 console ports at the same time; if you insert the USB cable into the router,
the RS232 port is disabled.
Cisco NCS 560-4 Router Hardware Installation Guide
92
Installing the Cisco NCS 560-4 Router
2
Position of the IM Card cables (fan tray side) on the
cable management bracket
4
Postion of the power supply cables on the cable
management bracket