Cisco NCS 560-4 Hardware Installation Manual page 24

Standard Warning Statements
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations. Statement
1040
Warning
To prevent the system from overheating, do not operate it in an area that exceeds the maximum recommended
ambient temperature of 149°F (65°C). Statement 1047
Warning The chassis should be mounted on a rack that is permanently affixed to the building. Statement 1049
Warning Invisible laser radiation may be emitted from disconnected fibers or connectors. Do not stare into beams or
view directly with optical instruments. Statement 1051
Warning Class 1M laser radiation when open. Do not view directly with optical instruments. Statement 1053
Warning Class I (CDRH) and Class 1M (IEC) laser products. Statement 1055
Warning IMPORTANT SAFETY INSTRUCTIONS: This warning symbol means danger. You are in a situation that
could cause bodily injury. Before you work on any equipment, be aware of the hazards involved with electrical
circuitry and be familiar with standard practices for preventing accidents. Use the statement number provided
at the end of each warning to locate its translation in the translated safety warnings that accompanied this
device. Statement 1071
Warning
This is a Class A Device and is registered for EMC requirements for industrial use. The seller or buyer should
be aware of this. If this type was sold or purchased by mistake, it should be replaced with a residential-use
type. Statement 294
Warning This is a class A product. In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures. Statement 340
Warning
This equipment is in compliance with the essential requirements and other relevant provisions of Directive
1999/5/EC.
Cisco NCS 560-4 Router Hardware Installation Guide
16
Preparing for Installation