Graphics Inter Faces; Digital Display Interfaces; Lvds/Edp Interface; Table 7: Lvds/Jili Connector J8 Pinout - Kontron COMe Ref. Carrier-I T6 TMIP User Manual

2.2. Graphics Inter faces

2.2.1. Digital Display Interfaces

The COMe Ref. Carrier-i T6 TMIP provides the following digital display interfaces (DDIs):
 DDI1 from the COMe module is directly mapped to the DisplayPort++ connector, J12, through a redriver IC, U5
 DDI2 from the COMe module is directly mapped to the Mini DisplayPort++ connector, J17,through a redriver IC, U9
 DDI3 from the COMe module is directly mapped to the Mini DisplayPort++ connector, J16,through a redriver IC, U7

2.2.2. LVDS/eDP Interface

The COMe Ref. Carrier-i T6 TMIP supports a 24-bit, dual-channel LVDS interface via the LVDS/JILI connector, J8.
The following table provides pinout information for the LVDS/JILI connector, J8.

Table 7: LVDS/JILI Connector J8 Pinout

LVDS/JILI Connector (J8)
If eDP support is required, the COMe Ref. Carrier-i T6 TMIP may optionally be equipped with a Mini DisplayPort++
connector, J9, instead of the LVDS/JILI connector, J8.
To use the eDP interface, the COMe module installed must also support eDP.
www.kontron.com
Pin Signal
1 LVDS_BKLT_CTRL
2 LVDS_A0-
3 LVDS_A0+
4 LVDS_VDD_EN
5 LVDS_A1-
6 LVDS_A1+
7 NC
8 LVDS_A2-
9 LVDS_A2+
10 GND
11 LVDS_A_CK-
12 LVDS_A_CK+
13 GND
14 LVDS_A3-
15 LVDS_A3+
16 LVDS_I2C_DAT
17 LVDS_B0-
18 LVDS_B0+
19 LVDS_IC2_CK
20 LVDS_B1-
COMe Ref. Carrier-i T6 TMI - User Guide Rev. 1.4
Pin Signal
21 LVDS_B1+
22 GND
23 LVDS_B2-
24 LVDS_B2+
25 GND
26 LVDS_B_CK-
27 LVDS_B_CK+
28 GND
29 LVDS_B3-
30 LVDS_B3+
31 +5V
32 +5V
33 +5V
34 +5V
35 LVDS_BKLT_EN
36 GND
37 GND
38 +12V
39 +12V
40 +12V
// 23