Getting Started Tig - Linde RYVAL 200 MIG MAN PFC Operating Manual

7. GETTING STARTED TIG

Getting started must be consistent with technical data and conditions of use.
Fig. 11 Connecting the ground cable and the torch
1. Connect the torch B12 to the terminal of welding cables (-)B13, to the gas
connector B14 and connector B10.
2. Connect the ground cable to the terminal of welding cables (+) B9 and the
ground clamps B11 to the welder B7 or to the welding table.
3. Connect the machine to power supply and turn the main switch on the
back panel to ON.
4. Connect the
ADJUSTMENT OF GAS FLOW
5. Press the button 19 to select the mode TIG
6. Use the potentiometer 31 to adjust
7. Use the potentiometer
8. By means of the potentiometers 36
9. By means of the potentiometers 37
Linde AG, Linde Gas Deutschland ©
gas hose and gas flow adjustment described
30 to adjust
18/21
the welding current.
the time of Slope down.
you can change the time of
you can change the time of
in 6.4
.
Pre
Post
Gas.
Gas.