Power Hook Up - Challenge JO Instructions And Parts Manual

5.0 Installation Guide
6. Locate the drill alignment guide shipped in the manual. Place it against the backgauge and
side guide as shown in Figure 5. Bring the hollow drill down with the handle and notice the
alignment of the drill in reference to the hole in the guide. By moving the drill base, align the
drill with the hole in the guide (Figure 5). (NOTE: leave the backgauge and side guide
locked in position - adjust the mounting position of the drill-to-table assemblies to align drill to
the alignment guide.)
7. When the drill has been sufficiently aligned, finish tightening the mounting bolts under the
table. Start with the bolts at the rear of the machine. (They can be accessed without moving
the drill- see Figure 6.)
8. After tightening the two rear bolts, tilt the drill on its back and tighten the two remaining bolts.
Return the drill to the upright position.

5.4 Power Hook Up

The JO Paper Drill is factory wired to 115 Volt specifications. It is important that the power source
complies with the electrical specifications of the machine. We recommend that this machine be
plugged into a 15 Amp circuit.
your drill.
10
Figure 5
Figure 6
Always disconnect the power cord when cleaning, servicing or lubricating