Table of Contents
Advertisement
INSTALLATION
NOTE: All guards and instruction plates are in-
stalled for your safety and information and must
remain on the machine as shipped from the fac-
tory.
Uncrating the Paper Drill
Unless otherwise specified, this machine is shipped in
a cardboard container with the cutting stick knockout,
backgage, and table removed. These items are packed
separately. The machine should be unpacked carefully
so as not to damage any of the machine parts.
Immediately after uncrating, check off parts received
against the packing list. Also, examine for any physical
signs of damage incurred during shipment. The
machine is inspected before and after crating at the
factory. The responsibility for filing a claim against the
carrier for damages incurred during shipment rests with
the receiver of the goods (FOB our factory).
The machine is held in place on its shipping skid by
means of wooden blocks. Remove these blocks and
then carefully position the machine on the floor.
Clean all parts with a commercial cleaning solvent (such
as C.R.C.) before installing or using the machine.
Installing the Table
The table is held in place with four socket head machine
screws and washers provided. Simply position the
table, line up the holes, and tighten the screws.
Installing the Backgage
To install the backgage you must first remove the
pressure foot assembly (held in place with two knurled
screws). While facing the front of the machine, hold
the backgage with the opening toward you and slip it
on the front of the table. Then slide the gage back on
the table and fasten to the table with the two thumb
screws provided.
Installing the Table Height Adjustment Rod
First remove the back cover. Then, with the spring
plunger out of the adjustment rod, turn the adjustment
rod on the threaded rod until approximately 1" (2 cm)
of thread are engaged. Next, install the spring plunger
by turning it in all the way, then turn back 1/4 to 1/2
turn (see fig. 2).
8
Top Cover
Spring Plunger
Final Installation
Attach the pressure foot assembly in place with the
two knurled screws provided.
Place the cutting stick knockout in position. Place paper
shims as necessary on the cutting stick knockout.
Place the drill block in the table.
Insert the tapered head of the hollow drill into the
spindle. Be sure the drift hole cover is in place before
operation.
Power Hook Up
The JF Drill is factory wired to the customer's
specifications. It is important that the power source
complies with the voltage and current specified on the
name plate of this machine. We recommend that this
machine be plugged into a 15 amp circuit.
OPERATION
Starting the Machine
The power for this machine is supplied by a single motor
which directly drives the spindle. It is started and
stopped by a rocker switch located on the inside of the
top cover toward the right side of the machine (fig. 3)
"OFF"
Adjustment
Rod
Threaded Rod
fig. 2
Inside of top cover
"ON"
fig. 3
F.330-J/APR 97
Advertisement
Table of Contents
