Installation Guide; Inspecting Shipment; Uncrating The Paper Drill; Assembly Instructions - Challenge JO Instructions And Parts Manual

5.0 Installation Guide

5.0 Installation Guide
Refer to the parts lists and drawings in the back of this manual for part identification and orientation,
as necessary.
All guards and instruction plates are installed for your safety and information and must remain on the
machine as shipped from the factory.

5.1 Inspecting Shipment

This machine has been carefully packed to prevent damage during shipment. However, claims for
damage or loss are the responsibility of the recipient. Inspect all shipments as soon as they are
received. If there is any noticeable damage, note it on the freight bill. Visual and/or hidden damage
must be reported to the claims department of the carrier within 15 days. Contact your dealer if you
need any assistance. Check the contents of the box against the packing list on page 6. Make sure
there are no missing items.

5.2 Uncrating the Paper Drill

Unless otherwise specified, this machine is shipped in a cardboard carton with the table, back-gauge
and handle removed. These items are packed separately in the box. The machine should be
unpacked by carefully removing the carton so as not to damage any of the machine parts.
Clean all parts with a commercial cleaning solvent (such as CRC) before installing or using the
machine.

5.3 Assembly Instructions

You will need the following tools to assemble your JO Drill:
5/32" Allen wrench (supplied)
1/2" hex wrench (supplied)
Check contents against the Packing List (page 6).
Contents consists of:
1 - Table Asm., 1 – Handle, 1 – Back-gauge Asm., 1 - Tool kit, 1 - Drill Head Asm.
8
Figure 2