11.0 Accessories for Challenge Paper Drilling Machine
Diameter x Drill Capacity
1/8" x 5/8" (3.2 x 16mm)
5/32" x 11/8" (4 x 29mm)
3/16" x 15/8" (4.8 x 41mm)
7/32" x 2" (5.6 x 51mm)
¼" x 2" (6.3 x 51mm)
17/64" x 2" (6.7 x 51mm)
9/32" x 2" (7.1 x 51mm)
5/16" x 2" (7.9 x 51mm)
11/32" x 2" (8.7 x 51mm)
3/8" x 2" (9.5 x 51mm)
13/32" x 2" (10.3 x 51mm)
7/16" x 2" (11.1 x 51mm)
½" x 2" (12.7 x 51mm)
11.2 Challenge Drill-Ease Lubricant Stick
Cat. No. 4688
This lubricating stick provides a dry stainless lubricant which has many uses throughout the printing
plant. It is specially recommended for use on hollow drills for easier drilling, particularly when drilling
clay-coated stock. It eliminates binding and excessive heating of the drill. Will not discolor the stock.
CARE MUST ALWAYS BE TAKEN WHEN USING STICK AND HANDLING DRILLS.
11.3 Challenge Drilling Blocks
Cat. No. A-4682
These Challenge 1
1
packages of 12.
11.4 Challenge Fiber Blocks
Cat. No. KK-474
These tough, 1
/
" (38 mm) fiber cutting blocks are recommended for all cornering and slitting
1
2
operations. Sold in packages of 12.
11.5 Challenge Power Sharpener
(115 Volt / 60 HZ only)
Cat. No. A-6450
This power drill sharpener plugs into any standard 115 volt, 60 cycle, AC outlet. Handles Challenge
and other taper shank drills.
26
Teflon Coated Hollow Drill Bits
/
" (38 mm) wood drilling blocks are for round hole drilling operations. Sold in
2
Cat. No.
TCD-2-3
TCD-52
TCD-3
TCD-72
TCD-4
TCD-174
TCD-92
TCD-5
TCD-112
TCD-6
TCD-132
TCD-7
TCD-8