Installation & Setup; Inspecting Shipment; Uncrating; Cleaning - Challenge Handy-Drill Instructions And Parts Manual

6.0 Installation & Setup
6.0 Installation & Setup

6.1 Inspecting Shipment

This machine has been carefully packed to prevent damage during shipment. However, claims for
damage or loss are the responsibility of the recipient. Inspect all shipments as soon as they are
received. If there is any noticeable damage, note it on the freight bill. Visual and/or hidden damage
must be reported to the claims department of the carrier within 15 days. Contact your dealer if you
need any assistance. Check the contents of the box against the packing list on page 7. Make sure
there are no missing items.

6.2 Uncrating

The Handy-Drill weighs approximately 70 lbs (32 kg). DO NOT risk personal injury or damage by
attempting to move machinery with makeshift equipment or inadequate help. This machine is
shipped enclosed in a corrugated carton. Open the top of the carton and carefully lift machine out
and set on to work surface.

6.3 Cleaning

After unpacking, wipe down all machine panels and surfaces with a clean cloth as necessary.

6.4 Assemble Loose Items

1. Insert the wood drilling block into the hole in the tabletop.
2. Insert the hollow drill bit into the spindle. Push the bit firmly into the spindle. The drill bit is sharp;
do not push on the end of the drill bit. Injury may result.
3. The machine was shipped with the drilling depth set above the drilling block. Adjust the drilling
depth according to Section 7.2 Set Drilling Depth.

6.5 Power Hook-Up

Connect plug to any standard 120 Volt outlet.
10
SHOCK HAZARD! Possible shock could cause personal injury or death.
Figure 2 – Main Power Disconnect