Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Challenge CDT16180
Summary of Contents for Challenge CDT16180
- Page 1 18V CORDLESS DRILL DRIVER CDT16180 LX400...
-
Page 2: Safety Instructions
SAFETY INSTRUCTIONS e) When operating a power tool outdoors, use an extension cord suitable for outdoor WARNING! Read all safety warnings use. Use of a cord suitable for outdoor use and all instructions. Failure to follow reduces the risk of electric shock. the warnings and instructions may result in f) If operating a power tool in a damp electric shock, fire and/or serious injury. - Page 3 connection of dust extraction and 5) Battery tool use and care collection facilities, ensure these are a) Recharge only with the charger connected and properly used. Use of dust specified by the manufacturer. A charger collection can reduce dust-related hazards. that is suitable for one type of battery pack may create a risk of fire when used with 4) Power tool use and care...
- Page 4 pack, it may explode. expose to rain or water. 8. Do not charge a damaged battery pack. 3. Do not charge non-rechargeable 9. Replace any damaged supply cords on batteries. your charger. 4. If the supply cord is damaged, it must be 10.
-
Page 5: Component List
COMPONENT LIST 1. On/Off switch 2. Forward/Reverse rotating control 3. Keyless chuck 4. Torque adjustment ring 5. Handle 6. Double ended bits 7. Battery pack unlocking button 8. Battery pack ACCESSORIES 3-5hrs charger 2pcs Double ended bits Battery(assembled on product) HELPLINE NO 08707252949... -
Page 6: Vibration Information
TECHNICAL DATA Charger voltage 230-240V~50 Hz Battery voltage Rated no load speed 550min Max torque 15 N.m Number of clutch position 16+1 Chuck capacity 10 mm Max. drilling capacity Steel 8 mm Wood 18 mm Battery capacity 1000mAh Weight 1.7 kg NOISE AND VIBRATION DATA A weighted sound pressure 74 dB (A) A weighted sound power 85 dB (A) - Page 7 appropriate). If the tool is to be used regularly then invest in anti vibration accessories. Avoid using tools in temperatures of 10 C or less. Plan your work schedule to spread any high vibration tool use across a number of days. HELPLINE NO 08707252949...
-
Page 8: Recharging Batteries
RECHARGING BATTERIES A fully discharged battery will take approximately 3-5 hours to reach full NOTE: Before using the tool, read charge. When charging is complete, the instruction book carefully. unplug the charging plug from the wall socket. 1. BEFORE USING YOUR CORDLESS DRILL Your battery pack is UNCHARGED and WARNING:... - Page 9 Warning: Do not operate for long holding the inner chuck ring with one hand, periods at low speed because and with the other hand turn the outer excess heat will be produced internally. chuck ring anti-clockwise to open. Insert drill, drill must reach the bottom 2.
-
Page 10: Disposal Of An Exhausted Battery Pack
drill bit into the work-piece, applying only Position 1 is the lowest torque (screw enough pressure to keep the bit drilling. driving force) and position 16 is the highest Do not force or apply side pressure to torque (screw driving force). Position elongate a hole. - Page 11 Environmental protection Waste electrical products should not be disposed of with household waste. Please recycle where facilities exist. Check with your Local Authority or retailer for recycling advice. If faults can not be remedied, contact the Helpline on 08707252949 GUARANTEE This product is selected for DOMESTIC USE ONLY and not for business use.