Vinotemp WINE-MATE WM1500 HTD-TE Use And Care Manual page 7

• If top exhaust, cut another rectangular opening at the top of the cabinet to
the length and width of the top exhaust (see Fig.2.2 & 2.3).
• Make 2 holes at the ceiling and install the ¼" inside diameter wood thread
inserts (see Fig.2.1 & 2.3).
• Place the gaskets (1/2" foam tape) on the gasket lips (see Fig 2.4).
• If top exhaust, place another gaskets along the top exhaust at the top of
the cooling unit (see Fig.2.9).
• Move the cooling unit towards the mounting sides and push to press the
gaskets.
• Fasten the 2 brackets and use 7/16" wrench to tighten the two ¼" screws
(see Fig 2.5, 2.6 & 2.7).
• If top exhaust, install another top exhaust grille at the top of the cabinet
(see Fig 2.8).
• Plug the cooling unit in receptacle.
• Plug the wine cabinet.
Fig. 2.1 MOUNTING CUTOUT AND SCREW INSERT
- 6 -