Vinotemp WINE-MATE WM1500 HTD-TE Use And Care Manual page 18

l.
a. Improper room insulation & seal
5. Unit running
too long
b. Exhaust restricted
c. Room too large
d. Ambient temperature higher >
e. Dirty Condenser
f. Improper condenser air flow
a. Post-compressor
6. Fan motor
running but
b. Incorrect power supply
compressor
c. Incorrect or loose wirings
not running
d. Failed components
e. Liquid
a. Fan blade stuck
7. Compressor
b. Incorrect or loose wirings
running but
c. Failed motors
fan not
running
a. Air sensor
8. Temperature
fluctuating
a. Post-compressor
9. Fan running
too long
a. Anti-short cycle
10. Unit not
starting ,
but
temperature
Failed components
°
90 F
fan
mode
refrigerant
compressor
fan
mode for humidity modulation
- 17 -
l. Check compressor windings, start
relay and overload protector
a. Check for insulation, gasket and
door opening
b. Leave minimum required clearance
for the exhaust side and leave
minimum required clearance for the
fresh air intake side
c. Check for excessive size or increase
setting
d. Check for installation location or
increase setting
e. Clean condenser
f. Air short-circulation
running a. Check for fan running time FON
b. Check for proper voltage
c. Check all wirings and connections
d. Check start relay, start capacitor,
overload protector, compressor.
in the e. Call service for OEM information.
a. Check for proper clearance
b. Check all wirings
c. Call service for checking open or
shorted windings
a. When using an air sensor, the wine
bottle temperature
controlled
temperature. If the set-point is 55
with the differential 4F, the cooling
unit turns
temperature and turns off at 55
air temperature. The average air
temperature is 57
wine temperature is around 57+/-
°
0.5 F. The air is light enough to
change so quickly that it maintains
relatively
temperature that would prevent wine
bottle temperature from fluctuating.
running a. Reset FON
a. Reset AC
is mainly
by the average air
°
F
°
on at 59 F of air
°
F of
°
F, and then the
constant average