Vinotemp WINE-MATE WM1500 HTD-TE Use And Care Manual page 14

1. Press the SET +
then release the keys.
2. Press again the SET +
displayed, then release the keys. The first parameter Hy will be displayed.
3. Press up/down keys
4. Press the "SET" key to display its value.
5. Use up/down keys
6. Press "SET" to store the new value.
7. To exit: Press SET +
PARAMETER
Set
Hy
temperature regulation differential
AC anti-short cycle delay (min)
Con compress on with probe faulty (min)
CoF compress off with probe faulty (min)
CF
rES
dLy temperature display delay (min)
ot
US
LS
idF defrost cycle interval time (hour)
MdF defrost cycle endurance time (min)
ALC
ALU
high temperature alarm
ALL
AFH alarm recovery differential
ALd temperature alarm delay (min)
FnC
Fon fan on with compressor (min)
FoF fan off with compressor (min)
Note:
• The parameter Fon is used to adjust the humidity in the wine cabinet. The
higher Fon is, the higher relative humidity will be.
• The parameter FnC = C-y (on with compressor and on during defrost) with
idF = 8 and MdF = 15 can be used to defrost more efficiently in case there is
much frost.
•
The unit turns on at set-point plus regulation differential Hy after anti-short
cycle AC has elapsed and turns off at set-point.
7) Manual Defrost
Press the DEF key for more than 2 seconds and a manual defrost will start.
keys for 3 sec until the "°C" or "°F" LED starts blinking,
keys for more than 7sec until the Pr2 label will be
/ to select the required parameter within 10 sec.
to change its value within 10 sec.
or wait 15sec without pressing a key.
DESCRIPTION
°
set-point ( )
°F/ °C
temperature unit (
display resolution
°
probe calibration ( )
°
maximum set-point ( )
°
minimum set-point ( )
temperature alarm type
°
(
°
low temperature alarm (
fan operating mode
°
( )
)
rE: relative to set-point
)
)
°
( )
C-n: on with compressor & off during defrost
- 13 -
VALUE
55
4
10
15
30
F: Fahrenheit
in: integer
1
0
65
50
24
30
10
10
5
120
0
15