Vinotemp WINE-MATE WM1500 HTD-TE Use And Care Manual page 13

2.1 LED Functions
LED
3) Alarm Signals
3.1 Code Description
MESSAGE
P1
Temperature probe faulty
HA
High temperature alarm
LA
Low temperature alarm
CA
3.2 Alarm Recovery
Probe alarms P1", start a few seconds after the fault in the related probe; they
automatically stop a few seconds after the probe restarts normal operation.
Check connections before replacing the probe. Temperature alarms "HA", "LA"
automatically stops as soon as the temperature returns to normal value. Alarm
"CA" (with i1F=PAL) recovers only by switching off and on the instrument.
4) Temperature Set-Point
4.1 How to see the set-point
1. Press and immediately release the SET key, the display will show the set-point
value.
2. Press again and immediately release the SET key or wait for 5 seconds to
display the probe value again.
4.2 How to change the set-point
1. Press the SET key for more than 3 seconds until the "°C" or "°F" LED starts
blinking and the set-point will be displayed.
2. To change the set value, press the up/down keys
3. To store the new set-point value, press the SET key again or wait 10 sec.
5) Parameter Programming
MODE
ON
Flashing Anti-short cycle enabled
ON Defrost cycle enabled
ON
Flashing Fan delay after defrost enabled
ON
ON Temperature measuring unit
Flashing
CAUSE
External alarm
- 12 -
FUNCTION
Compressor enabled
Fan enabled
Alarm occurring
Programming mode
FUNCTION
Compressor switching to Con and CoF
Outputs unchanged
Outputs unchanged
All outputs off
/ within 10 sec.