Maintenance - Panasonic TK-AS66-ZEX Instruction Manual

Maintenance

Important
 Do not use detergents, cleansers, paint thinners, benzine, alcohol or kerosene for cleaning purposes. If, for instance,
a detergent has been used by mistake, wipe the surface with a damp cloth to remove all traces of the detergent.
(Otherwise, the detergent may get mixed in with the water running through the Alkaline Ionizer or the plated
parts may be damaged or peel off or the plastic parts may become damaged, discolored or deformed.)
 Use of cleansers may also impair the workings of the outlet pipe and cause trouble.
 Do not use brushes or other implements made of metal (since they may leave scratch marks).
 Do not use a tool to tighten up the nut (since the nut may be damaged).
Main unit, bypass selector and acidic water stand
 Soak a soft cloth in water, wring it out well, and use
it to wipe the units and parts.
 Use a toothbrush or other implement to remove
foreign matter at the shower part.
Bypass selector mount coupling (fi lter and water intake)
The water volume will be reduced if foreign matter is allowed to clog the fi lter at the bypass
selector mount coupling. Follow the steps below to clean the fi lter.
1
Loosen the nut, remove the bypass selector,
and take out the fi lter.
 Set the bypass selector to "Purifi ed".
Nut
Bypass selector
3
Install the bypass selector.
 Make sure any foreign matter is not attached on the end of the faucet and gasket inside of the bypass selector.
 Install the fi lter without fail.
 After installing the bypass selector, run water for about 5 seconds at the "Unpurifi ed" or "Shower" setting.
Install the parts
in the correct
sequence
EN34
TK-AS66-ZEX̲En.indb 34 TK-AS66-ZEX̲En.indb 34
Shower part
2
Gasket
Filter
Gasket washer
Plated part
Wash the fi lter and
water intake.
Clean using a
toothbrush or
Filter
other implement.
Water intake
Tighten up the nut until the
bypass selector does not turn.
 Make sure the bypass
selector is not inclined.
2017/01/30 15:04:22 2017/01/30 15:04:22