Panasonic TK-AS66-ZEX Instruction Manual page 27

Setting the diff erence

in height between the
main spout and acidic
water spout
It is recommended that this
height be set in order to
improve the accuracy of the
water output display.
Before proceeding with
the setting, check the
diff erence in height
between the main spout
and acidic water spout
without fail.
 Use the Alkaline Ionizer
with a height diff erence
between the two spouts
of 10 to 50 cm.
Control panel
Main spout
Height
diff erence
LCD display
Acidic water spout
Note
 When is pressed in steps 2 to 6, the previous screen is restored. After the settings are completed, the
previous screen will not be restored even when the button is pressed.
 Once the settings have been set, they will be stored in the memory until other settings are established (until
they are changed).
 Displays on the screens indicated will be in Chinese even if the English display mode is established.
TK-AS66-ZEX̲En.indb 27 TK-AS66-ZEX̲En.indb 27
Operation
1
Turn off the faucet, and
press on
the control panel for 1
second.
2
Press .
3
Press , and
select the " 計量條件
設定 ".
4
Press .
 To perform "Correcting the
water output display", proceed
to step 5 on P. EN28.
5
Press .
6
Press ,
and select the height
diff erence setting.
 Set a value in accordance
with the height diff erence
which you measured.
7
Press .
<The setting is fi nished>
8
Press , and
select " 是 ".
9
Press .
LCD displays
Mode selection
Setting mode
Check mode
Setting mode
pH fi ne adjustment
Continue mode
Water output buzzer
Setting mode
Electrolysis signal
Measurement condition setting
Exit
Measurement condition setting
Height diff erence
Compensation
Measurement condition setting
10 to 20 (cm)
20 to 30 (cm)
30 to 40 (cm)
e.g.) To select "30 to 40 (cm)"
Measurement condition setting
10 to 20 (cm)
20 to 30 (cm)
30 to 40 (cm)
After about
3 seconds
Height diff erence is now Exit the setting mode?
set to 30 to 40 (cm) Yes
No
Exit the setting mode?
Yes
No
e.g.)
2017/01/30 15:04:19 2017/01/30 15:04:19
EN27