Operation - Ryobi ECO-2335 User Manual

GB
F D
ADJUSTMENTS
By pressing down on the machine arm, lower the
■
wheel and check clearance and maximum cutting
distance (distance from adjustable stationary vice
where wheel enters) to front of machine base slot.
Adjust if necessary. Re-tighten depth stop bolt lock
■
nut securely.
CAUTION
Do not start your abrasive cut-off machine
without checking for interference between the
wheel and the machine base support. Damage
may result to the wheel if it strikes the machine
base support during operation of the machine.
Tighten the depth stop bolt with the wrench provided.
■
WARNING
Cutting steel will cause sparks. Do not operate in
the presence of combustible or flammable
materials. Failure to heed this warning could
result in a fire or serious personal injury.

OPERATION

APPLICATIONS
Use only for the purposes listed below:
Cutting all types of ferrous metals such as 50.8 mm
■
(2") x 152.4 mm (6") steel framing studs.
Cutting hard metal iron stock such as square bar
■
stock and angle iron.
Cutting metal tube and pipe stock.
■
POWER SUPPLY
Before operating your cut-off machine, check your power
supply and make sure it meets the requirements listed on
the tool's data plate. A substantial voltage drop will cause
a loss of power and machine overheating.
Common causes of power loss and machine overheating
are insufficient extension cord size and multiple tools
operating from the same power source.
SWITCH
To turn your cut-off machine ON, depress the
■
switch trigger located in the handle portion of the
machine arm.
To turn it OFF, release the switch trigger.
■
E I P NL S DK N FIN
English
CUTTING WITH YOUR CUT-OFF MACHINE
(Fig. 10-11)
WARNING
Do not attempt to cut wood or masonry with this
cut-off machine. Never cut magnesium or
magnesium alloy with this machine. Failure to
comply could result in serious personal injury.
To prevent machine movement or tipping during cutting
procedure, secure cut-off machine in place to a
workbench or work surface that is also secure.
WARNING
Always use the vice on the cut-off machine to
prevent accidents that could result in possible
serious personal injury.
WARNING
Never stand or have any part of your body in
line with the path of the wheel. Doing so may
cause an accident resulting in possible serious
personal injury.
WARNING
Large, circular, or irregularly shaped material
may require additional means of clamping to be
secured in place adequately for cutting. Use "C"
clamps that can be mounted along the left and
front side of the machine base. Also use blocks
to hold material securely. Failure to comply could
result in serious personal injury.
To avoid accidental start up of your cut-off machine,
always make sure the switch is off before connecting to
power source. Failure to heed this warning could result in
serious personal injury.
CUT-OFF (Fig. 12-13)
A cut-off is made by cutting across the width of the
workpiece. A straight crosscut is made with the
adjustable fence set at the zero degree position.
Angled cut-offs are made with the adjustable fence set at
some angle other than zero.
To cut with your cut-off machine:
Firmly secure the material to be cut by using the
■
machine's vice (or adjustable fence and vice clamp).
Loosen the fence quick lock and fence bolts securing
■
the fence.
Rotate the adjustable fence to the angle needed.
■
Retighten fence quick lock and fence bolt to secure
■
the fence.
18
GR H CZ RUS RO PL