Ryobi ECO-2335 User Manual page 21

GB
F D
FEATURES
POWER CORD
The power cord is H07RN-F type with length 1.8 m
earthing.
ABRASIVE WHEEL
A 355 mm abrasive wheel is included with your cutoff
machine. It will cut materials up to 115 mm thick or
233 mm wide, depending upon the thickness or width of
the material and the angle setting at which the cut is
being made.
SELF-RETRACTING LOWER WHEEL GUARD
The lower wheel guard provides protection from each
side of the wheel. It retracts over the upper wheel guard
as the wheel is lowered into the workpiece.
VICE CLAMP
A vice clamp has been provided with your cut-off
machine. It is located on the end of the vice screw and
provides greater control by clamping the workpiece to
the fence. It also prevents the workpiece from creeping
toward the wheel during a cutting operation.
ADJUSTABLE FENCE
The fence on your cut-off machine has been provided to
support the workpiece and provide clamping support to
the vice for holding your workpiece securely when
making all cuts. It is an adjustable fence that has been
provided to make your cut-off machine more versatile.
It adjusts from 0° to 45° to the left and right for making
angled cuts. The hole pattern allows it to be moved
forward when making cuts in tall or thick stock, such as
square stock or tube stock. The hole pattern allows it to
be moved back when making cuts in stock that is thin or
wide, such as angle stock.
QUICK LOCK-RELEASE LEVER
A lock lever has been provided on your cut-off machine.
This feature allows you to open and close the vice clamp
quickly without repetitive turning of the vice crank handle.
CARRYING HANDLE
For convenience when carrying or transporting your cut-
off machine from one place to another, a carrying handle
has been provided on top of the machine arm.
To transport, turn off and unplug your machine, then lower
machine arm and lock it in the down position. Use the
transport chain to lock machine arm in the down position.
E I P NL S DK N FIN
English
SPINDLE LOCK BUTTON
A spindle lock button has been provided for locking the
spindle whilst changing the abrasive wheel. Pull the
spindle lock button while installing, changing, or removing
wheel only.
ADJUSTMENTS
WARNING
To prevent accidental starting that could cause
possible serious personal injury, assemble all
parts to your cut-off machine before connecting it
to power supply. Machine should never be
connected to power supply when you are
assembling parts, making adjustments, installing
or removing wheels, or when not in use.
As mentioned previously your cut-off machine has been
factory assembled and adjusted. After extended use and
wear, the wheel will need to be replaced with a
new one.
WARNING
A 355 mm wheel is the maximum wheel capacity
of your cut-off machine. Never use a wheel that
is too thick to allow outer flange to engage with
the flats on the spindle. Larger wheels will come
in contact with the wheel guards, while thicker
wheels will prevent the bolt from securing the
wheel on the spindle. Either of these situations
could result in a serious accident and can cause
serious personal injury.
REMOVAL AND INSTALLATION OF THE
WHEEL (Fig. 3)
Unplug your cut-off machine.
■
WARNING
Before performing any adjustment, make sure
the tool is unplugged from the power supply.
Failure to heed this warning could result in
serious personal injury.
Push down on machine arm and remove chain from
■
hook on motor housing to release machine arm.
Raise machine arm to its full lifted position. Be
■
cautious when raising, machine arm is spring loaded.
Pull lower wheel guard upward, exposing wheel bolt
■
that secures abrasive wheel to wheel arbor.
Pull the spindle lock button and rotate bolt until
■
spindle locks, preventing shaft from rotating.
15
GR H CZ RUS RO PL