INSPECT EXTENSION CORDS PERIODICALLY and RULES FOR SAFE OPERATION replace if damaged. USE SAFETY GLASSES. DRESS PROPERLY. Do not wear loose clothing, gloves, Use face or dust mask if the cutting neckties, rings, bracelets, or other jewelry. They can get operation is dusty.
Page 6
INSPECT TOOL CORDS PERIODICALLY and if REPLACEMENT PARTS. All repairs, whether electrical damaged, have repaired at your nearest Ryobi Authorised or mechanical, should be made at a Ryobi Authorised Service Center. Stay constantly aware of cord location Service Centre. and keep it well away from the rotating wheel.
Net Weight 24 kg RULES FOR SAFE OPERATION Fence Angle ONLY USE A CUT-OFF WHEEL RATED FOR 4000 RPM Right 45° OR GREATER and manufactured in compliance with Left 0° ANSI B7.1. Always store wheels in a dry place with little temperature variation.
CARRYING HANDLE FEATURES For convenience when carrying or transporting your cut-off machine from one place to another, a carrying handle (23) has KNOW YOUR ABRASIVE CUT-OFF MACHINE been provided on top of the machine arm (11). (Fig. 1-2) To transport, turn off and unplug your machine, then lower Before attempting to use your machine, familarise yourself machine arm (11) and lock it in the down position.
Page 9
Using the 8 mm hex key (16) provided, securely tighten ADJUSTMENTS socket head bolt. Note: Bolt has right hand threads. Turn bolt clockwise to tighten. REMOVAL AND INSTALLATION OF WHEEL TO REMOVE (Fig. 4) WARNING: Unplug your cut-off machine. Do not overtighten socket head bolt. Overtightening can cause the new wheel to crack, resulting in premature WARNING: failure and possible serious personal injury.
DEPTH STOP ADJUSTMENTS The depth stop limits the wheel's downward travel. It Install socket head bolt through lock washer and flat allows the wheel to go below the machine base enough washer into machine base. to maintain full cutting capacities. Check and adjust fence to desired cutting angle.
OPERATION WARNING: APPLICATIONS Never stand or have any part of your body in line with the path of the wheel. Doing so may cause an accident (Use only for the purposes listed below) resulting in possible serious personal injury. Cutting all types of metals such as 2 in. x 6 in. steel framing studs.
WARNING: To ensure safety and reliability, all repairs — with the exception of the externally accessible brushes — should be performed by a Ryobi Authorised Service Centre. BRUSH REPLACEMENT (Fig. 13) Your cut-off machine has externally accessible brush assemblies (17) that should be periodically checked for wear.
4. Circuit fuse is blown 4. Replace circuit fuse. 5. Switch is damaged or burned out. 5. Have the switch replaced at your nearest authorised Ryobi service agent. and request a voltage check from the power company. Motor does not reach full speed or 1.
Page 14
Motor stalls, blows fuses, or trips 1. Switch is defective. 1. Have the switch replaced at your circuit breakers. nearest authorised Ryobi service agent. 2. Voltage from source is low. 2. Request a voltage check from the power company. 3. Fuses or circuit breakers are 3.
Page 15
RYOBI NEW ZEALAND PTY. LTD. AUCKLAND: 27 Clemow Drive, Mt Wellington, N.Z. Tel: (09) 573 0230 - Free Call: 0800 279 624 - Fax: (09) 573 0231 - www.ryobi.co.nz Contact during normal business hours. For your record and to assist in establishing date of purchase (necessary for in-guarantee service) please keep your purchase docket and this form completed with the following particulars.
Need help?
Do you have a question about the ECO-2435 and is the answer not in the manual?
Questions and answers