Maintenance And Storage - Teeter Hang Ups FlexTech Series Assembly Instructions Manual

FIGURE 24
Maintenance & Storage
Maintenance
• To clean the Inversion Table, wipe down with a damp cloth. Do not use abrasive cleaners
or solvents.
Storage
• Remove the Angle Tether from the U-Bar located on the underside of the Table Bed.
• Pull the Height-Selector Locking Pin and slide the Main Shaft in all the way to the last hole
setting.
• Release and engage the Pin in the storage setting.
• Rotate the Table Bed opposite from use until it has turned 180° and rests against the
Crossbar of the A-Frame.
• Pull up on the Spreader Arms to fold the A-Frame (Figure 24), leaving the A-Frame legs
open to a width of 12" for stability.
NOTE: This operation may pinch fingers if not done slowly and carefully.
Tipping Hazard: For upright storage, leave A-Frame open wide enough to remain
stable, or secure to the wall to prevent tipping. In households with small children,
the inversion table should be stored flat on the floor, not upright.
19
WARNING
!