Maintenance - Teeter Hang Ups EP-950 Assembly Instructions Manual

ASSEMBLY
ADJUSTMENTS / MAINTENANCE / STORAGE
CHANGING THE ROLLER HINGE SETTING
•
Stand with your legs on either side of the Main
Shaft.
• Reach under each Roller Hinge with your index
fi ngers. Use your thumbs to release the locks over
the Roller Hinges (See Figure 21).
• Lift both sides of the table out of the A-frame at
the same time. You may rest the table on the
Crossbar of the A-frame.
• Unlock the Cam Locks for each Roller Hinge.
Change the Roller Hinges to the desired setting (A,
B or C) (Figure 22).
• Re-lock the Cam Locks. Replace the Roller Hinges
into the hinge plates of the A-frame.

MAINTENANCE

•
To clean the Table Bed, wipe down with a damp
cloth. Do not use abrasive cleaners.
STORING THE INVERSION TABLE
• Loosen the De-rattler knob.
• Pull the height-selector locking pin and slide the
Main Shaft in all the way to the fi nal hole setting.
Engage the pin in the storage setting.
• Rotate the table opposite from use until the table
has turned 180 degrees and rests against the
Crossbar on the A-frame.
• Pull up on the spreader arms to fold the
A-frame (Figure 23). WARNING: This operation
may pinch fi ngers if not done slowly and carefully.
Read the Owner's Manual thoroughly before using your Teeter Hang Ups
Inversion Table. Improper settings could result in serious injury or death!
Teeter Hang Ups
WARNING
!
Figure 21
A B C
Figure 22
Figure 23
12
EP-950